![]() ![]() fan splitter&cm_re=coboc_fan_splitter-_-12-423-163-_-Productįor two fans use one of these (or a 12" long version of same). (Your CPU cooler should be plugged into the CPU_FAN header and is NOT linked to the case fans.)įor three fans you could use one of these. There really should be one fan plugged into the header marked "CPU" (because that is the one that sends back a fan speed), even though that is NOT the real CPU cooler. It needs to be fastened down securely so it does not make accidental contact and ground out something. When you use a Splitter (or a Hub) it will send back to the mobo SYS_FAN header the speed signal from only ONE of its fans (the header cannot handle more), so you will not "see" the speeds of all the fans, but this does NOT affect control of fan speeds. A HUB (you do not want) has an additional cable that must plug into a SATA or Molex power output connector from the PSU. A SPLITTER has one cable that plugs into a mobo SYS_FAN header, and two or more output cables OR perhaps sets of header pins on a circuit board where you plug in your fans. To do that you need a Splitter, but you do NOT need a HUB. ![]() But given that the fans use at max 0.18A current per fan, you are allowed to connect up to 5 of them together to the SYS_FAN header. You have not told us how many of these fans you got. Now, that's a small issue right there because there is only one header, and more fans that that. ![]() This will fit onto the mobo's only SYS_FAN header at middle rear of the mobo. One ends in a standard female 4-hole fan connector about 3/8" wide with two ridges running down one side. Your fans ARE compatible with your mobo.Details follow.Įach fan has THREE cables from it, I believe. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |